To make a set of six 16-inch square napkins, pick up a Materials for Running Stitch Napkins kit containing…
Cut two 17-inch squares from each of the Tana Lawn pieces.
Cut six 17-inch squares from the Muslin.
Pin a Tana Lawn piece to a Muslin piece, right sides together.
Sew the two pieces together with a ½-inch seam allowance, leaving a 3-inch gap unsewn in the middle of one side. Back stitch at the beginning and end of this seam.
Repeat for the five remaining pairs of Tana Lawn and Muslin.
Turn all the napkins right sides out through the unsewn gap and press them flat, making sure their corners are nice and pointy.
Pin the two layers together along all four edges.
Cut a 21-inch length of the Pearl Cotton and tie a simple overhand knot 4 inches from one end. Thread the opposite end through a hand sewing needle.
You will use the Pearl Cotton to stitch the two sides together with a small running stitch. Starting a few inches from a corner and 1/8 inch from the edge, insert the needle through the Tana Lawn side of the napkin and exit on the muslin side. There will be a 4-inch tail of Pearl Cotton on the Tana Lawn side. Ignore it for now.
Take a series of roughly 1/8-inch running stitches parallel to the edge of the napkin, 1/8 inch in from the edge. You can take a few stitches at a time as you go, as shown above.
When you have 5 inches left of the Pearl Cotton, make a French knot on the Tana Lawn side of the napkin. Wrap the thread twice tightly around the end of the needle close to the threads exit point.
Then insert the tip of the needle right at the point where you just came out and pull it through just the Tana Lawn layer, exiting an inch away. Pull the thread through, which will create a French knot. Snip the thread at the exit point to hide the end.
Please note, all beginning and ending knots will be on the Tana Lawn side of the napkin.
To hide the tails, thread each onto a hand sewing needle. Insert the needle into just the Tana Lawn layer, right next to the knot. Pull it through just the Tana Lawn layer, exiting about an inch away. Snip the thread end at the exit point to hide it. Repeat with all the ends and youre all done!